project smudger

Yep

Sent from my C6903 using Tapatalk

 

The paints supposed to be on the part you're painting, not the gun (Nor your kitchen floor for that matter) :roflmao:

 

And what ratio did ya thin the paint down too and what pressure did you spray at ?

 

40 psi and paint 1 part thinners 2 part activater 1 part

Sent from my C6903 using Tapatalk

 

You put activator in the red paint ?

 

Yes

Sent from my C6903 using Tapatalk

 

If the red is a base coat it should be thinned 50/50 thinner.
No hardner is added.
The clear coat is 2 to 1 ie 100ml clear to 50ml hardener and 10% thinner if required.

Trying to help you here because the finish on them panels is awful.
If you need any help pm me.

 

Nope wrong that's how the paint was supplied also that isnt the finish

Sent from my C6903 using Tapatalk

 

And the clear is 2:1

Sent from my C6903 using Tapatalk

 

Just saying as I do it for a living so good look with the sanding pal

 

I only followed the instructions for the mixing and its ghost pearl over red and more clear over so it's going look a bit ruff till its sanded down

Sent from my C6903 using Tapatalk

 

No hardner goes in the base coat that why the finish is so poor.
You describe a 3 stage pearl which is a red base a pearl coat and a clear coat.
Only the clear coat has hardener in it.
The base and pearl are just thinned upto 50/50.
You should not need to flat it before the clear coat or after the clear coat.

 

Activater not hardener

Sent from my C6903 using Tapatalk

 

Same thing

 

No idea I'm not experienced I never had it was the last paint but it come as a set 500 ml paint 500 ml activater 1000ml thinners and says it's a 2 litre kit

Sent from my C6903 using Tapatalk

 

Should be like this straight out of the gun.

 

Me thinks I might be asking ians help when I look to spray my nc30 tank

 

The red was nice and shiney before I applied the ghost coat

Sent from my C6903 using Tapatalk