Not finished yet, but run out of time The big hole and the 2 ones at the side were where the old plate light was. the half hole on the right is cos i am an idiot. Plate too high so couldnt get key into seat lock.. IMO much better than it was. The plate is smaller than i expected, but it clears the exhaust which was the main concern ... Not convinced, gonna see what it looks like when the holes are tidied up. Most likely get a reflector to put over them... The alternative is a 100 quid aftermarket one, which i am trying to avoid if i can get away with it. Before After
Fuck me, Deanoet - spend some of that 100 you saved on soap, water and some T-Cut or Mer and clean it, you mucky skank!!! (looks miles better, by the way :rofl
The "muck" above the exhaust is actually discoloured / melted plastic as the exhaust was a tad closewhen first fitted. TBH the seat cowl is a bit fecked, seems to have gone brittle around the front where it connects to the frame, falling apart. Not sure if it has been over tightened at some point, or if they are just shit quality Looks fine on the surface, but behind the side panels it isnt great. May clean it saturday, back from work at 2, so weather dependant.
Infortunately not cansa. If you look to the left it is where the seat lock is. To put it there the plate would have to be tiny. You cant book me officer. It is a safety message.